Jungle Gym Landing Page

Simple Assembly

For The Jungle Gym!

The indoor toddler climbing toy allows children to experience a healthy lifestyle through exercise, while also ensuring a fun playtime!

Accessory Checklist

Part A

Assembly instructions

Let’s Begin

This step-by-step manual will guide you to put your Jungle Gym together! Once you’re done, your child is free to enjoy endless playtime possibilities!

Step 1

Secure Five (5) wooden rod B for both wooden pillar 1 & 3, insert One (1) wooden circle A in the first wooden rod. Tightened the wood pillars with Five (5) a screws on both sides.

Step 2

After installation, the jungle gym ladder would be display as shown in the diagram below.

Step 3

Secure Five (5) wooden rod B for both wooden pillar 2 & 4, insert One (1) wooden circle A in the first wooden rod. Tightened the wood pillars with Five (5) a screws on both sides.

Step 4

After installation, the jungle gym ladder would be display as shown in the diagram below.

Step 5

Insert One (1) screw cap c in wooden pillar 2 & tighten wooden pillar 1 with One (1) d screw.

Step 6

Place and insert One (1) wooden rod C into wooden pillar 4 and tighten with One (1) e screw. Insert and tighten One (1) f plastic screw in wooden pillar 3.

Step 13

Press & Raise the button on bed support to adjust the height.

Step 7

After installation, insert the swing set L into wooden rod C.

Step 15

Complete the installation for bassinet.

Part B

Assembly instructions

Step 1

Secure Two (2) wooden rod D at the bottom of wooden pillar 3 & 4 and secure them with Two (2) a screws.

Step 2

Place wooden pillar 5 & 6 into the rods, tighten One (1) e screws on the top and Two (2) a screws at the bottom of both wooden pillars.

Step 3

Place wood connector E on the side of wooden pillar and tighten with One (1) e screw. Insert One (1) f plastic screw at the edge of the wood connector E.

Step 4

Complete the installation as shown in the diagram below.

Step 5

Place another wood connector E on the other side of wooden pillar and tighten with One (1) e screw. Insert One (1) f plastic screw at the edge of the wood connector E.